-
EOS3-sink/source rates are piecewise constant, how to set up?
As mentioned in the title, I want to set the piecewise constant sink/source rate as shown in the attached figure, but I can't achieve the desired result after setting it many times in petrasim,…
-
Last bock in CO2TAB file
Hello everyone: I have difficulties to understand the last block in CO2TAB file and search for help from here. I know the previous blocks are pressure, temperature, viscosity,…
-
TOUGHREACT/ECO2N:CANNOT FIND PARAMETERS AT ELEMENT * 1*
Hi Everyone, I'm new at using ECO2N of TOUGHREACT. And the following problem is encountered when I used PetraSim to simulate. It's a simple model. And I model a strata from -2260m to -2900m below…
-
Tough2-MP post-processing and visualization
Hi everybody, can anyone, please, advise on software to extract and visualize results from TOUGH2-MP with ECO2N? I realise that EXT is not an option to extract results to tecplot,…
-
CONVP block in solute.inp
Hello everyone: I have a question about implementing CONVP (chemical convergence bounds for time stepping) in solute.inp. I firstly make MOPR(10)=2 to make simulator read CONVP block.…
-
Why MESHMAKER not writing MATERIAL to MESH file: 2D Radial heterogenous Mesh: what is wrong?
hello moderator/everyone i adapted TSN_Radial example from MESHMAKER V1.5 example: but when i run it, it makes mesh file but it it it does not write material to mesh file.…
-
call TOUGH in jupyter notebook and PyTOUGH
Hi All, I am using PyTOUGH to automate TOUGH simulation. However, when I try to call TOUGH in Jupyter notebook with this command subprocess.call(["path_to_my_tough3_executable(tough3-eos1)",…
-
Run ends early
Hi, I was working on a larger block mesh using a doublet configuration for an aquifer, over 10 years. When I made the mesh finer, the simulation timed out and quit after 16 hours.…
-
Pre-Processing using Matlab
Hai everyone, I am new to using tough2 simulation. Do anyone has experience in using Matlab as pre-processing to run the tough2? I tried to follow the code from the internet which is…
-
zero pore pressure boundary condition
Can TOUGH3 define pore pressure Dirichlet boundary condition as zero values? In order to validate the coupled THM code, I have to compare the numerical solution to analytical solution.…





