-
Question about Gas Relative Permeability ($k_{rg}$) calculation for IRP=7 in TOUGHREACT v4.13 (EOS3)
Hello everyone, I am a university student and recently started using TOUGHREACT v4.13 (with the EOS3 module). I have a question about the gas relative permeability (k_rg) formula used when IRP = 7…
-
TMVOC
Hello everyone. I want to learn something about TMVOC from everyone.When I was simulating the initial groundwater flow using TMVOC, the simulation results showed that gas disappeared and was…
-
Error Message
Hello everyone, I am getting an error message when I run my T2well-ECO2N file. The error message is: At line 210 of file t2f.f (unit = 5, file = 'stdin') Fortran runtime error:…
-
Help TOUGHREACT 3.32 with EOS7 Module for Air Injection into an Aquifer
I am using TOUGHREACT 3.32 with the EOS7 module to simulate air injection into an aquifer. The total simulation time is 50 days. During the run, the iteration progress is very slow with small time…
-
Porosity change by pressure change in TOUGHREACT
Hello, TOUGH community, In my flow simulation with TOUGHREACT, I observe pressure changes by fluid injection. Here, I find that without chemical reactions,…
-
T2WELL/ECO2M PT failure
Dear TOUGH users, I am modeling co2 injection using t2well/eco2m into an aquifer. I am outside the saturation line (Tsurf = 35C), but the pressure at the wellhead cell after 60 seconds gets up to…
-
EWASG
Here's the English translation of your request: "Hello, I am using the **EWASG module** for **hydrogen storage in an aquifer**, but the OUT file is reporting an error.…
-
Error with 0D batch simulation in TOUGHREACT v4.13
Hello everyone, I recently purchased TOUGHREACT v4.13 and am trying to reproduce the batch experiment from this paper: https://www.mdpi.com/2073-4441/14/19/3160 I am using the EOS1 module and have…
-
TMVOC
Hello everyone.I am conducting a pollution simulation of a DNAPL point source leak, but the simulation results are completely incorrect. Could you please point out what the problem might be?…
-
TMVOC
Hello everyone.I am conducting a pollution simulation of a DNAPL point source leak, but the simulation results are completely incorrect. Could you please point out what the problem might be?…




