-
Thermodynamic Database for CO₂ Storage in Icelandic Basalts
Hello everyone, I've been running sample problem 5 on CO₂ storage in sandstone using TOUGHREACT V3.32. I'm interested in running this problem considering a basaltic formation, however,…
-
How to debug tough3 correctly
I want to debug this code. When configuring tough3-eco2n, the command used is"/configure.sh --build-type=DEBUG --eos=eco2n --no-x11 --petsc-dir=/home/zhigao/petsc-3.17.…
-
How should the enthalpy be correctly specified when simulating the process of air injection into an aquifer using TOUGH3/EOS3?
Hi I am currently attempting to conduct a simulation for CAESA, specifically modeling the process of air injection into an aquifer. Due to persistent convergence issues,…
-
Pressure Drop When Allowing Dissolution/Precipitation of Minerals
Hello everyone, After I run a pressure initialization on the reservoir (REACT(1) = 2), I see that the gridblocks have pressures within the vicinity of that specific in PARAM.…
-
Simulation of the non-isothermal analysis of co2 injection
Hi, everyone i am now tyring to simulate the co2 injection under the non-isothermal situation byTOUGHREACT V1.2 ECO2N). For simplicity, i cosed the reactive transport in this simulation and focus on…
-
How to do the post-processing for the TOUGHREACT output file?
Hi guys! I wonder how to do post process of the .dat file. I want to see the mesh so i put the file into Tecplot, but i only see this image below. Hope you give me some methods to solve that.…
-
TOUGHIO CO2 Leakage Along a Fault Generate MESH and INCON files
What went wrong with this step?
-
Modify capillary pressure unit by unit
Hi, everyone I have recently read a lot of coupling programs carried out based on the TOUGH series of software, and I noticed that they have an equation for modifying the capillary pressure,…
-
Query on Early Steady State in Methane Discharge Model at 1% Hydraulic Gradient
Dear TOUGH2 Group, I am modeling methane discharge from a 1m^3, source producing methane at a rate of 1.16E−7 kg/(s⋅m^2). The objective is to observe accumulation and migration through a homogeneous…
-
About the design of boundary
Hi, everyone, I'm working on setting the boundary conditions for no flow and constant pressure in a model using TOUGHREACT v1.2 ECO2N. I have two questions: For the no flow boundary condition,…