-
Questions about TOGA
Hello everyone, When I was learning toga, I have come across a question and I hope to get your answer. The result of the same inp file running on my computer is inconsistent with the standard result.…
-
closed loop borehole + reservoir capability
Hello community, I am new to TOUGH family. I want to simulate a closed-loop geothermal heat exchanger (eg: similar to U-tube) coupled to reservoir modeling.…
-
Increasing Injection Rate
I am currently working on a model where the reservoir permeability is only a few mD, but the injection rate is set at 3 kg/s. In the existing model, when the injection rate reaches 0.…
-
TOUGH3 installation on PC updates: Install Ubuntu Terminal and then install TOUGH3
If the operating system is Windows 10, a better option than Cygwin is Ubuntu Terminal. Updated instruction for TOUGH3 installation on Ubuntu Terminal can be found here (Installation File,…
-
Toughreact courses or workshops
Hello everyone, I'm new to using toughreact and would like to learn a bit more and improve. Does anyone know if there will be any courses or workshops this year or next? Thanks
-
How to resolve the flow non-convergence in eco2n module?
Hello, I'm trying to simulate CO2 geological storage in aquifer composed of andesite rocks at high temperature condition, 200 degC. The CO2 was injected for 10 years and run a 1000year simulation.…
-
TOUGH3/ECO2M input problems
Dear TOUGH community, I am using TOUGH3/ECO2M for modeling two injection scenarios: i) liquid CO2 (5C, 100 bar) and ii) SC-CO2 (35C, 100 bar) at the wellhead at constant temperature.…
-
Assistance Needed with Methane Volume Quantification in EOS7C Model
Hello, I am currently using EOS7C to model the development of a gas bubble gas beneath a low-permeability hillslope. With initial guidance from a previous forum question answered by@Alfredo…
-
How many VOCs can be included in a TMVOC simulation?
How many VOCs can be included in a TMVOC simulation? These are my simulation of injecting Tetrachloroethylene (STD) and Xylene- (STD) at a rate of 1E-5 kg/s for one year. Thanks a lot! Sincerely!
-
An issue (experience) with very large mesh
Hi all Just to share my experience. I have a very large mesh (6E5 grid cells). Surprisingly the name of some elements start with "END" (like END 1, .. END10 etc).…




