-
Vertical well and Perforated interval
hello Everyone, am trying to model an R-Z system with a vertical wellbore for depressurization using lower bottom hole pressure I am confused as to what boundary conditions and how to set these.…
-
Area adjustment factor
I am currently doing some simulations of core based experiments using the kinetic model. With regards to terms in the equations I would like to confirm the notation.…
-
About auxiliary equations.
In tough+hydrate equilibrium model without inhibitor, what auxiliary equations (besides three governing equations) are used to construct a solvable set of equations?…
-
Suppress CO2 dissolution in TOUGH+RealGasBrine
I am trying to suppress CO2 dissolution in TOUGH+RGB (set CO2 solubility in brine as 0) to match with another model that doesn't take CO2 dissolution into consideration.…
-
How to set initial temperatures below zero
Hi again. I am attempting to model some occurrences where the boundary temperature is a couple of degrees below 0 degC. Whenever I set the temperature in INCON below zero,…
-
Compare [cumulative CH4(m3) ] from Well_Time_Series vs Hydrate_Info
Hello everyone I have a very simple problem Tough+Hydrate (v1.5) : I m trying to compare Methane production from the two sources (i) released from HYDRATE DISSOCIATION (ii) Total Production at the…
-
Tough+Realgasbrine
Hi there, I'm planning to attend the short course of Tough+Realgasbrine in September, is it a new module going to be released? Do you have any idea when will it be available? Thanks.