-
ECO2M: Extracting Vector Orientation
Hello, I'm using TOUGH2-ECO2M and interested in extracting the "direction/orientation" of the vector output data (flow of heat, flow of fluid, etc), ideally generated in the same CSV format as in…
-
Maximum Extraction Rate for nodes on DELV?
Hello all, I wasn't able to find out in the T3 manual if there is a way to cap the output from a GENER element set on DELV such that the initial rates are not so huge.…
-
PETSC configure command failed-when compile TOUGH3
I got the "PETSC configure command failed" error at compiling TOUGH3. I need some help. Thanks. cd /Users/wuhao/TOUGH3/TOUGH3v1.0/TOUGH3-Code/esd-tough3/build/tpl-build/tpls/petsc/petsc-3.7.…
-
TOUGH3 vs TOUGH2-MP Printout of Mass fractions in single phase
Our understanding is that adding all component mass fractions of a phase add up to one. In TOUGH3 (or at least using eos3), it would appear that this is not the case.…
-
Restart problem with T2Well
Hi, I assume T2Well has the same set up for "restart" as Tough2 or Tough3. I have summarized the sequence of my primary and secondary runs below to ask for advise.…
-
cannot find -laztec
Hi folks, I am doing a clean TOUGH3 installation on a Linux system and want to use the PETSc solver. I have no interest in using the AZTEC solvers. But it seems I cannot finish building TOUGH3…
-
Error in installation
Can somebody help in rectifying the error encountered as shown in attached figure. Thank you in advance