-
Toughreact courses or workshops
Hello everyone, I'm new to using toughreact and would like to learn a bit more and improve. Does anyone know if there will be any courses or workshops this year or next? Thanks
-
How to resolve the flow non-convergence in eco2n module?
Hello, I'm trying to simulate CO2 geological storage in aquifer composed of andesite rocks at high temperature condition, 200 degC. The CO2 was injected for 10 years and run a 1000year simulation.…
-
TOUGH3/ECO2M input problems
Dear TOUGH community, I am using TOUGH3/ECO2M for modeling two injection scenarios: i) liquid CO2 (5C, 100 bar) and ii) SC-CO2 (35C, 100 bar) at the wellhead at constant temperature.…
-
Assistance Needed with Methane Volume Quantification in EOS7C Model
Hello, I am currently using EOS7C to model the development of a gas bubble gas beneath a low-permeability hillslope. With initial guidance from a previous forum question answered by@Alfredo…
-
How many VOCs can be included in a TMVOC simulation?
How many VOCs can be included in a TMVOC simulation? These are my simulation of injecting Tetrachloroethylene (STD) and Xylene- (STD) at a rate of 1E-5 kg/s for one year. Thanks a lot! Sincerely!
-
An issue (experience) with very large mesh
Hi all Just to share my experience. I have a very large mesh (6E5 grid cells). Surprisingly the name of some elements start with "END" (like END 1, .. END10 etc).…
-
Simulation result files always maintain their original size
Hello everyone, I am using TOUGHREACT to simulate the chemical reaction of CO2 injection into deep saline reservoirs and caprocks. The input files I defined are as above,…
-
Simulation result files always maintain their original size
Hello everyone, I am using TOUGHREACT to simulate the chemical reaction of CO2 injection into deep saline reservoirs and caprocks. The input files I defined are as above,…
-
The results of Example 2 in the ECO2M manual
Hello. I have a question about Example 2 of ECO2M. In Example 2 the residual water saturation is set to 0.3. However, in the results, the water saturation is 0 near the injection well.…
-
Commingled injection well modeling
Hi, I am trying to model a commingled injection well which is a well completed through multilayers (5 layers in my model). Every layer in my model is represented by a single grid block in the Z…