-
EOS1 non-convergence
Hello! I am a beginner in TOUGHREACT. I ran it based on the input file provided by the author of a paper. However, when I ran toughreactV2.0, I found that the model did not converge and the program…
-
Reservoir Temperature Change
Hi all, In the current simulation I'm running, the reservoir temperature change is far less significant than I would expect (50 kg/s for 30 yrs with only localized grid block temp change).…
-
PETSC configure command failed-when compile TOUGH3
I got the "PETSC configure command failed" error at compiling TOUGH3. I need some help. Thanks. cd /Users/wuhao/TOUGH3/TOUGH3v1.0/TOUGH3-Code/esd-tough3/build/tpl-build/tpls/petsc/petsc-3.7.…
-
Carbonate cement distribution in 1D model
Hi, tough users I created a 1D model (EOS1) to simulate the carbonate cement. The initial temperature (15-26 C) and pressure (0.2-5Mpa, equal to 500 m depth) distribution are included in INCON file.…
-
Local vs global sensitivity analysis with iTOUGH
Hello everyone, I am currently attempting to conduct a local sensitivity analysis using iTOUGH. After going through the user's guide, it appears that the sensitivity analysis is primarily presented…
-
Help deciding EOS7C or EOS7CA
Hello, I am a researcher looking to model gas (CH4) accumulation beneath a capillary barrier in the shallow subsurface. Currently I have EOS7C available for use but I am considering purchasing TOUGH3…
-
Mesh is truncated-Meshmaker v 1.5
Hello everyone. I am trying to create a mesh, R=200m and Z = -190m. It has multiple layers. I have added all the info and the file runs, but the mesh is created only up to a depth of -94m and no more.…
-
TOUGHREACT and MODFLOW grid
Is TOUGHREACT AND MODFLOW grids interchangeable? Let's say I have a 3D MODFLOW grid for a project and now I want to use the same grid, potential same flow solution and transfer it to TOUGHREACT to…
-
Converting single porosity mesh into dual porosity (dual-perm) mesh
By any chance, does anyone know a way of converting single porosity mesh elements file into dual porosity (dual-perm) mesh model file (with correct connections)? Would appreciate any feedback.…
-
EOS2 non-convergence
I'm new to TOUGHREACT and have built a simple mesh and created a temperature and pressure gradient with INCON. Now, I am trying to run flow.inp through TOUGHREACT (EOS2) before I move to the solute.…