-
EOS9:FOLLOWING TWO STEPS THAT CONVERGED ON ITER = 1
Hello, It looks like I am running into this exact issues described on page 10 of the Tough2 user manual (copied below). What suggestions do you have when this occurs?…
-
How to set up semi-analytical method to calculate heat transfer in t2well?
Dear TOUGH community users, Could you please advise on configuring the semi-analytical method for computing heat transfer in t2well-eco2m? As far as I understand,…
-
Run result SMCO2 is always 0
Shalom: This is an example of website 3.0 why SMCO2 has been 0 Thank the reply
-
Temperature dependence cation exchange
Hello, I included cation exchange in my simulation, in which I simulate injection of hot (90 degrees C) water into a relatively cold aquifer with the exact same composition.…
-
ECO2N / ECO2M: handling of wettability in a dry zone
Hi folks, When exposing the initially brine-filled grid cells near injection point to CO2 injection, a dry zone is established. At a certain condition of flow and rock properties water saturation…
-
How to find a grid index
Hi, I am having trouble finding a grid index. I used FOFT to show temperature changes over time. However, I could not find the specific grid index I wanted to show the results for.…
-
In ECO2N, the injected co2 gas is mixed with a certain amount of so2
hello: I would ask how the injected co2 gas in ECO2N contains a certain amount of so2. Is the setting method like me correct. Thank you for the reply. Thank you
-
TOUGHREACT ECO2N
I want to use TOUGHREACT V3.0 ECO2N simulate the mineral changes caused by the co injection of different concentrations of SO2 and CO2, mainly observing gypsum precipitation.…
-
ECO2N(I would like to ask what figure CO2 means? Why is the mole fraction greater than 1?thanks)
I would like to ask what figure CO2 means? Why is the mole fraction greater than 1?thanks





