-
Reaction rate >0 at equilibrium
I am running a simple test problem representing dissolution of a hypothetical "glass" mineral in a single grid cell. The solid phase consists entirely of glass, the pore fluid is water.…
-
How to set up well bore
Hi TOUGH community, I am trying to incorporate a well bore into my simulations in TOUGHREACT, and I am confused on how to set up my mesh. Please, kindly Assist.
-
how to use RESTART to inherit the minerals fractions and change P T?
Hi, My model is 1D with 10*10*400 meter. Firstly, I renamed the save and savechemical to INCON and inchemical in the first simulation, and copied these two files to the second simulation folder.…
-
time.out won't output the data of the last timestep
So my last timestep is 8.64e3 sec, but the time.out the last data in time.out is Is there any setting? I don't want to go the .tec file to find the cell by XYZ, thanks!
-
modify output flowdata.tect
Dear all, I 'm using EOS1 with TOUGHREACT V4.13omp and I would like to modify the source code to output in the flowdata.tec file the density of the different phases with their specific internal…
-
Error when trying to output the time series
So, I have 40000+ elments, and I want to output all of them's data, so I put all the elements in the solute.inp, for example But then I have the error Elements for which to output time series:…
-
Temperature dependence cation exchange
Hello, I included cation exchange in my simulation, in which I simulate injection of hot (90 degrees C) water into a relatively cold aquifer with the exact same composition.…
-
In ECO2N, the injected co2 gas is mixed with a certain amount of so2
hello: I would ask how the injected co2 gas in ECO2N contains a certain amount of so2. Is the setting method like me correct. Thank you for the reply. Thank you
-
Stuck on Performing Simulation, and chdump.out stops writing resutls
It shows multi TIME=0 CHEM.ITRERATIONS is 1 for all of them So does this mean it doesn't converge on CHEM? Thanks
-
OUTPT section
I use cubes to construct an octahedron prism. The cross-section shape is shown in the attachment. The largest distance in three directions is 41, 41, 291. How do I write the OUTPT section? Thanks!
-
ECO2N(I would like to ask what figure CO2 means? Why is the mole fraction greater than 1?thanks)
I would like to ask what figure CO2 means? Why is the mole fraction greater than 1?thanks