1
Gas production units in TOUGH+ is it m3/d or Sm3/d in Hydrate_Status : T+H v 1.5
I am trying to figure out whether T+H v 1.5 reports Sm3/d in Hydrate status file or simply m3/d. If it is m3/d then how do i get the necessary Thermodynamic variables to change it to Sm3/d.
Moreover, the interface file no longer gives m3/d at the well/interface. so how to convert the mass rate kg/s for the volume
Looking forward to your reply
1 reply
-
I did a little more digging nd found out that units in T+H output file are Standard m3/sec and Standard kg/sec. the ratio between the mass and volume rates is always 0.679 which is density . see snapshot of density calculation at standard conditions attached for your reference. Moreover, T+H v 1.2 manual also states the values are standard.
