-
Carbonate cement distribution in 1D model
Hi, tough users I created a 1D model (EOS1) to simulate the carbonate cement. The initial temperature (15-26 C) and pressure (0.2-5Mpa, equal to 500 m depth) distribution are included in INCON file.…
-
chemistry did not converge at node
Hi，tough community users, I try to carry out the 1D fluid-rock modeling for meteoric water dissolution during 10e4 years. In the runlog file, I occasionally found this error,…
-
how to set initial temperature distribution
Hi，tough community users, I want to prepare the initial or stable pressure and temperature conditions for EGS. INDOM was introduced into my flow file. The UPPE1 reservoir is the top mesh having 1.…
-
how to use RESTART to inherit the minerals fractions and change P T?
Hi, My model is 1D with 10*10*400 meter. Firstly, I renamed the save and savechemical to INCON and inchemical in the first simulation, and copied these two files to the second simulation folder.…
-
low injection rate cannot work in 2D model
Hi, everyone. I am so sorry to interrupt you again for a same question. I want to simulate the dissolution and precipitation of sandstone in 2D model, which were induced by meteoric water injection.…
-
low injection rate can induce the EOS CANNOT FIND PARAMETERS?
Hi，everyone I want to simulate the dissolution and precipitation induced by meteoric water injection (toughreact332_EOS1). I set injection rate 9.5129E-02 kg/s during 2Ma,…
-
Re: How to set reasonable injection rate?
Attachment -
How to set reasonable injection rate?
Hi, everyone. I want to simulate the dissolution and precipitation induced by meteoric water injection. Firstly, I acquired the annual rain precipitation about 100 mm/a.…
-
How could charge diffierent boundary water at same model?
I set two types of boundary water in same model. And I want to charge first boundary water into reservoirs during 100-50 Ma, then charge the second one by same boundary elements sicne 50 Ma to…
-
How could charge diffierent boundary water at same model?
I set two types of boundary water in same model. And I want to charge first boundary water into reservoirs during 100-50 Ma, then charge the second one by same boundary elements sicne 50 Ma to…