-
New entries into Thermodynamic database
Hi, I am looking for a piece of advise on how to put a new entry for a new type of “Glass” into the database attached to ToughReact v3.3. Looking at the file I have,…
-
Restart problem with T2Well
Hi, I assume T2Well has the same set up for "restart" as Tough2 or Tough3. I have summarized the sequence of my primary and secondary runs below to ask for advise.…
-
T2Well-ECO2M case not running
Hello T2Well user community and superusers of Tough-ECO2xxx, Would be great if you are interested to look into this case and see the possible source(s) of error.…
-
ECO2N / ECO2M: handling of wettability in a dry zone
Hi folks, When exposing the initially brine-filled grid cells near injection point to CO2 injection, a dry zone is established. At a certain condition of flow and rock properties water saturation…
-
Using rock type "x" in T2Well
Hi T2well gives you the option to represent your tubular as a bundle of smaller tubes. I was trying to use rock type x (domain) right after the wellhead for representation of the wellhead choke.…
-
Pressure reporting: Tgh2-ECO2M
Hello ECO2M users, It is about pressure reporting of Tough2 when running a 1D radial model initialized with only water, flooded by CO2 at Its center using ECO2M. I get the following curves.…
-
T2well output files
Hello T2well users; I have just started using the code. I run a case with only a well model (reservoir represented solely by the last grid block at the bottom).…
-
JT Heat exchange in the cell containing well (using ECO2N)
Hello guys, In a non-isothermal run with gas (CO2) injection into an aquifer conditioned within supercritical domain of CO2, you expect some heating from compression and some cooling from expansion.…
-
T2Well-ECO2N wellbore-annulus modelling
Hello T2well-ECO2n users and advisors I am a new user of T2well, but familiar with Tough2 and several EOSs. Due to a limited number or limited variation in modelling samples following the code,…
Latest Posts