-
Maximum point for time-dependent injection
Dear all, I am trying to prescribe more points for cyclic injection scenario. I checked the TOUGH2 manual, which indicated to use LTAB for the number of points in the table of rate vs time.…
-
Format of INCON and SAVE file
Hi, I am trying to capture the block status (perm, poro, pressure etc). In the previous TOUGH2 or TOUGHREACT, the INCON or SAVE file could contain the perm, porosity, and pressure,…
-
Need help for EOS8 test
Dear all, I am trying to set up a test model using EOS8. I have generated the input file INFILE, and the mesh file separately. The mesh information (ELEME and CONNE0 are listed in this file.…
-
Initialization failed in TFREACT Econ
Dear everyone, Currently I am learning to build a simple model using EOS 7 (3,4,3,6), incorporating salt and CO2 injection. I have been stucking in the initialization step for quite a few days.…
-
CONNECTION in Mesh file
Hi, dear all, I am recently having problems in defining the connected elements in the MESH file. I opened the MESH file, and I found there is error in "CONNE" part (own code in writing the MESH…
-
TOUGH2 EOS1 viscosity
Hi, All I am using the EOS1 module to simulate fluidized sand mixing with water. I have read the tough2 manual. It seems like it is not available to modify viscosity,…
-
Suggestion in change the GENER
Hi, Dear all, I want to add a feature about delaying / shutting the production well with wellbore deliverability modulue. The manual said the production well with wellbore deliverability can not be…
-
How to switch between injection well to production well (time dependent)
Hi, Everyone, I am a PhD student. I need some urgent help in the TOUGH2. I wan to switch the well properties between the injection well and the production well during the simulation.…
-
Question about constant rate
Hi, everyone, I am trying to add the constant mass injection case in my model. Based on the manual, I uses the "mass" to represent the injector by using the dummy element.…
