0

Convergence problem with different mesh size

Dear Sir or Madam,

Sorry to disturb you. I was running a simple 1D transport model with surface complexation, but it never ends. However, I found it worked when I increased the mesh size from  x =1.28E-4 m to x =1.28E-2 m.

I attempted to revise my original refined model (since I need the refined mesh) by means of: 1) reducing the DELTEN and DELTMX; 2) changing the RCOUR; 3) changing the TOLTR and TOLCH. But all of them failed. Is there any other way I can try to revise it? Thank you!

Best regards,

Lang

1 reply

null
    • Lang
    • 6 yrs ago
    • Reported - view

    Additionally, the refined model worked well only for flow issue when I tried to set up the MOPR(1)=2 in flow.inp.

Content aside

  • 6 yrs agoLast active
  • 1Replies
  • 348Views
  • 1 Following