No primary variable data are displayed in output file.
Hello, I'm trying to mimic darcy's law with EOS1 module.
I made a model and simulate with the below input files (the first and second figure).
I think the simulation ends successfully, but when I open the output file I can not check the primary variables.
Only tricky message (...ITERATING... AT [ 1, 1] ; please refer to the third figure) comes out.
May I ask you why this signal occur and how to see the sets of primary variables?
Thank you.
2 replies
-
TOUGH2 automatically aborts or stops if there is no change in the primary variables during consecutive 10 time steps - see DX1 and DX2 in your output (3rd figure).
The final value of primary variables should have been written to the standard SAVE file.
- AA
-
I found what I want at the SAVE file. thank you for your kind reply.