0

Total No. of Aq. Complexes

Hi Everyone,

I just found from an error message that there is a default limitation for maximum number of aqueous complexes to be used in the TOUGHREACT simulation i.e 70. Is there any direct way to increase this number? Below is the error message i got. 

Too many derived aq. species in THERMOK.DAT
   Maximum allowed is:          70

For now i can fix this error by removing one of the primary species for e.g mg+2 from the simulation.  

Thanks & Regards,

Ali

1 reply

null
    • Dr.
    • MINGKUN_chen
    • 4 yrs ago
    • Reported - view

    hi,I have the same question,could you give me some advice?

Content aside

  • 4 yrs agoLast active
  • 1Replies
  • 497Views
  • 2 Following