0

How to get intermediate message during run-time?

Hi Everyone,

I am a new T2-MP user and I would like to know how to obtain messages about the simulation during the run (intermediate message).

 

Thank you very much for your help !

4 replies

null
    • JuDi
    • 6 yrs ago
    • Reported - view

    Hi Clemence,

    which kind of messages are you looking for?

    I usually monitor the runs by looking at the FOFT, GOFT and COFT files that are printed out and updated frequently. And you can define the printout times where the status of the entire model is printed out - under the TIMES section.

    Hope that helps.

    Julia

    • Clemence_GUALINI
    • 6 yrs ago
    • Reported - view

    Hi Julia,

     

    Thank you very much for your reactivity !

    Actually, what I am looking for is information message about the run during the simulation. I don't know if you are familiar with Eclipse, but we can get message like convergence issue and so on in a print file in .txt format. I am looking for something similar for Tough 2, file that would be printed during the simulation, so that I can see how my simulation is "going" and where there was issue....

     

    Thank you again for your help.

     

    Kind regards,

     

    Clem

      • JuDi
      • 6 yrs ago
      • Reported - view

      Clemence GUALINI 

      I see. so you probably looking for something like the PARAM section, especially the MOP parameters, which defines everything that can be printed out during a run and you'll find the info then in the OUTPUT file created with each TOUGH run.

      Julia

    • Clemence_GUALINI
    • 6 yrs ago
    • Reported - view

    Thank you Julia !

Login to reply

Content aside

  • Status Answered
  • 6 yrs agoLast active
  • 4Replies
  • 339Views
  • 2 Following