1

need help using EXT.exe

ext-error

Hello all,

I want to visualize TOUGH2 results, using Tecplot. So I tried to convert TOUGH2 output file to input file for Tecplot. After some time steps, this error appears>

forrt 1: severe <64> input conversion error, unit -5...

snapshot of the error appeared is attached.

any suggestion??

2 replies

null
    • Finsterle GeoConsulting
    • Stefan_Finsterle
    • 10 yrs ago
    • Reported - view

    Youhanna,

    I would have to see your TOUGH output file. Look for a potential formatting issue. For example, check whether there is at least one space between columns. Sometimes the space disappears if negative flow rates or capillary pressures are printed, in which case you have to globally replace "-0." with " -.". Of course this is just a wild guess...

    Stefan

    • Youhanna
    • 10 yrs ago
    • Reported - view
    Dear Stefan,

    Thanks a lot. I will check this and try it.
Login to reply

Content aside

  • 1 Likes
  • 10 yrs agoLast active
  • 2Replies
  • 1081Views
  • 2 Following