0

INITIALIZATION ERROR

Hello All,

Kenny or anyone

pls find attached my input file for tough+, i just finish inserting all my parameters from the MEMORY block using equilibrium with inhibitor, to my rock media of hydrate with underlying gas zones. In PARAM i use 5 years simulation time and ELEME and CONNE i got from the mashmaker.f96 70x1x326 grid block with 0.05m size wells.  I use the indom to assign the initial conditions of my 6 regions including the producer and injector wells. I also specify the bottom later of the hydrate and top layer of the gas zone to be the equilibrium region as suggested in hope for better intialization. My GENER block has two wells that run acros 75 layers vertically and i paste the MESH at the end. when i run this in CMD, it return with an error. 

something is wrong but i dont know where.

I really appreciate the help i have received thus far in this forum. God Bless

1 reply

null
    • Mahmud_muhammad_mahmud
    • 1 yr ago
    • Reported - view

    By aligning the parameters to the numbers 1-8  block after block without changing any parameter, it shows the same error until after i align all the numbers in blocks including TIMES among others and it still show error.  Then i realize that my NADD cant be 6 because i only have two records not four so i change it to 1 and it run for just few seconds. To be sure about the NADD i added two records of relative permeability and capillary pressure to the rock media block and it show error with NADD 1, when i change to NADD 2 as it should be it worked. But the run only lasted a few seconds, which bring me to my next problem.

    pls help me run the new modified input file, may be you can see what is  wrong.

Content aside

  • 1 yr agoLast active
  • 1Replies
  • 60Views
  • 1 Following