1

An error running the "CO2 leakage along a fault" example in toughio tutorial

Hi,

When I was trying to run the INFILE generated by the "generate_model_parameters_input_file" script, I had this error message:

"forrtl: severe (408): fort: (2): Subscript #1 of the array EVOL has value 1 which is greater than the upper bound of -1"

where does the problem lie? Thank you in advance for your help!

5 replies

null
    • Staff Scientist
    • Christine_Doughty
    • 2 yrs agoMon, September 19, 2022 at 4:31 PM UTC
    • Reported - view

    Please start by reviewing your INFILE, to make sure it does not contain anything unexpected.  If it looks good, you can post it here and I will take a look at it.

    • Sophia
    • 2 yrs agoFri, March 10, 2023 at 8:48 AM UTC
    • Reported - view

    Hi Rasha Moussawi

    I'm also learning the simulation of CO2 leakage along the fault recently, but I can't start. Can you give it to me?

    • Sophia
    • 2 yrs agoSat, March 11, 2023 at 12:30 AM UTC
    • Reported - view

    Hi Rasha Moussawi

    I am also learning the fault simulation of carbon dioxide in the development recently, but I am very confused. Can you share your model with me?

    Thank you very much

      • kenny
      • 2 yrs agoTue, March 14, 2023 at 5:27 PM UTC
      • Reported - view

      Sophia , The sample  "r1d" for ECO2M in the distribution package of TOUGH3 is a typical example for co2 leaking through fault. You may take it as a template for your own model.

      • Sophia
      • 2 yrs agoSat, April 1, 2023 at 5:05 AM UTC
      • Reported - view

      kenny I'm very sorry, Kenny, I searched for a long time and couldn't find the model you mentioned, can you share it with me, thank you very much.

Content aside

  • 1 Likes
  • 2 yrs agoSat, April 1, 2023 at 5:05 AM UTCLast active
  • 5Replies
  • 136Views
  • 5 Following