0

Format of file where pressure changes over time

Hello Everyone,

I am working on another model where pressures will change over time. I am looking through the manuals for the TOUGH code and am wondering if you could direct me to a specific location where the format for temporal pressure changes may be found. 

 

-JPM 

8 replies

null
    • Jordon_Massey
    • 4 wk ago
    • Reported - view

    I am trying to input a data from a table but have no clue how the values need to be configured to be read through the system.

    • yqzhang
    • 4 wk ago
    • Reported - view

    Search for TIMBC in the User's guide. Good luck.

    Yingqi

      • Jordon_Massey
      • 4 wk ago
      • Reported - view

       Thanks for responding! I searched for it in the user manual but nothing came up, however I did find the section on "Boundary Conditions and “Inactive” Elements". Is this where you were directing me? 

      For context I am trying to simulate the effect of barometric and hydrostatic pressure fluctuations on the pumping of Methane from beneath a low permeability capillary barrier.  

      Is it possible to temporally change both pressures for the model? Would I use a similar method to the one described in the "Boundary Conditions and “Inactive” Elements" section?

    • yqzhang
    • 4 wk ago
    • Reported - view

    See this page in TOUGH3 guide. Yingqi

    • Jordon_Massey
    • 4 wk ago
    • Reported - view

    Thank you!

    • Jordon_Massey
    • 3 wk ago
    • Reported - view

    Hello again,

    Yesterday I attempted to use the TIMBC block to provide a change in pressure at 9 different times.

    I changed MOP (21) for TIMBC use, and followed the format outlined in the user manual to the best of my knowledge. 

    However, I am unable to see any changes in pressures at the element at the times specified. 

    I have attached the infile to this chat for your review, can look over the infile and let me know what may be the issue.

    -JPM 

      • Jordon_Massey
      • 3 wk ago
      • Reported - view

       

      Dr. Zhang, thanks again for providing an update to our initial conversation. 

      I was wondering if you had some time to review my most recent comment. 

      I attempted to follow the directions from the TOUGH3 user manual but to no avail. 

      What do you think the issue is? 

      -JPM  

      • yqzhang
      • 3 wk ago
      • Reported - view

       I did not check the format but I see you have "B53  " as an element name, which I suspect checked you had "  B53" as element name in the MESH. In addition, you did not provide a large volume to keep the pressure.

      I suggest you go through the users guide to understand TOUGH inputs before you start your own simulations, which I think will help you to speed up your projects.

      Tank you,

      Yingqi

Content aside

  • 3 wk agoLast active
  • 8Replies
  • 24Views
  • 2 Following