0

How to print K(LIQ) and K(GAS)

Hi everyone,

I am using TOUGH2- ECO2N, and I would like to print the gas and liquid phase relative permeabilities. 

I checked in the manual, but I did not find the answer.

Could someone help me with this?

Thanks in advance,

Nathalie.

5 replies

null
    • Senior Geothermal Scientist - Vatnaskil Consulting Engineers
    • Andri_Arnaldsson
    • 4 yrs ago
    • Reported - view

    You can try to increase the value of MOP(5) in the PARAM block.

      • Nathalie_Collard
      • 4 yrs ago
      • Reported - view

      Andri Arnaldsson 

      Thanks Andri for your reply.

      I tried it, but it did not work.

      I am wondering which parameter I have to change.  

    • Curt_Oldenburg
    • 4 yrs ago
    • Reported - view

    Set MOP(5) equal to 8 and you should see a printout of all secondary parameters.  See the table on pg. 13 of the TOUGH2 user guide to find the position in the PAR array of krel.

    Make this a single time-step run to avoid an enormous output file.

    • Staff Scientist
    • Christine_Doughty
    • 4 yrs ago
    • Reported - view

    You could also try setting KDATA=3 (column 4 in the first line of the PARAM block).  I can't remember about TOUGH2-ECO2N for sure, but for some TOUGH versions this adds an extra section at each of your output times, with more variables of interest, including K(liq) and K(gas).

    • Nathalie_Collard
    • 4 yrs ago
    • Reported - view

    Thank you for your advice.

    It worked properly.

Content aside

  • 4 yrs agoLast active
  • 5Replies
  • 50Views
  • 4 Following