Hi everyone,
I am using TOUGH2- ECO2N, and I would like to print the gas and liquid phase relative permeabilities.
I checked in the manual, but I did not find the answer.
Could someone help me with this?
Thanks in advance,
Nathalie.
You can try to increase the value of MOP(5) in the PARAM block.
Andri Arnaldsson
Thanks Andri for your reply.
I tried it, but it did not work.
I am wondering which parameter I have to change.
Set MOP(5) equal to 8 and you should see a printout of all secondary parameters. See the table on pg. 13 of the TOUGH2 user guide to find the position in the PAR array of krel.
Make this a single time-step run to avoid an enormous output file.
You could also try setting KDATA=3 (column 4 in the first line of the PARAM block). I can't remember about TOUGH2-ECO2N for sure, but for some TOUGH versions this adds an extra section at each of your output times, with more variables of interest, including K(liq) and K(gas).
Thank you for your advice.
It worked properly.