1

Converting single porosity mesh into dual porosity (dual-perm) mesh

By any chance, does anyone know a way of converting single porosity mesh elements file into dual porosity (dual-perm) mesh model file (with correct connections)? Would appreciate any feedback. 

 

Regards,

Iman

1 reply

null
    • Finsterle GeoConsulting
    • Stefan_Finsterle
    • 2 mths ago
    • Reported - view

    Hi Iman,

    The procedure, specifically the MINC command in the MESHM block, is described in Appendix C of the TOUGH2 manual. I attach a short note with more detailed step-by-step instructions (specifically if you want different zones with different fracture spacings within the same model). Hope this is helpful.

    Good luck,

    Stefan

    MINC-Instructions
Login to reply

Content aside

  • 1 Likes
  • 2 mths agoLast active
  • 1Replies
  • 29Views
  • 3 Following