0

Control on outputs

Hi,

Based on what is written in iTOUGH2 and other related manuals, printout frequency follows the calibration times when OUTPU module is applied. Is there anyway to get rid of this and only have the outputs for the last time step? 

I tested KDATA with a negative integer, but it didn't work.

Thanks,

Ramin. 

2 replies

null
    • Senior Geothermal Scientist - Vatnaskil Consulting Engineers
    • Andri_Arnaldsson
    • 4 yrs ago
    • Reported - view

    Try to set MCYPR to a large number in PARAM block and specify dates in a TIMES block

      • Castleberry
      • 4 yrs ago
      • Reported - view

      Andri Arnaldsson 

      Here are the contents of Meshmaker (This makes a radial grid with radius 224m and depth 10m, 

      RZ2DL
      RADII
          3
          0.0e00    5.0e-2    7.0e-2                                                   
      LOGAR
         30          1.0e2    7.0e-2
      RADII
          1
         5.001e2      
      LAYER
          1
          1.0e01  

      I fail to  understand why RADII
          1
         5.001e2  (500.1 ) is mentioned here, Wht is the logic through which this value is inputted in the meshmaker file?

      someone please shed some light on this??

Content aside

  • 4 yrs agoLast active
  • 2Replies
  • 56Views
  • 3 Following