-
The simulation of the general three types of boundaries
Dear Sir or Madam, I just want to simulate the general three types of boundaries (without any specific cases) in the inlet end: Dirichlet, Neumann, and Robin.…
-
Convergence problem with different mesh size
Dear Sir or Madam, Sorry to disturb you. I was running a simple 1D transport model with surface complexation, but it never ends. However, I found it worked when I increased the mesh size from ∆x =1.…
-
Convergence problem for the surface complexation model
Dear Sir or Madam, Sorry to disturb you. I am Lang. I created a 1D transport model with surface complexation. I found it could not achieve convergence,…
-
Confused by the choice of boundaries based on the experiment
Dear Sir or Madam, Sorry to disturb you. I want to simulate the 1D contaminant transport using TOUGHTRACT v3.0. My experimental model is the simple constant injection with constant concentration C0…
-
Failure of flow.inp in TOUGHREACT v3.0 generated by PetraSim
Dear Sir or Madam, Sorry to disturb you. When I run the flow.inp generated by the PetraSim (TOUGHREACT v1.2) in TOUGHREACT v3.0, and I found it could not work.…
-
Failure of convergence in the simple 1D flow model
Dear Sir or Madam, I just built a simple 1D flow model (EOS9). I found it could not converge with my experimental parameters, however, it worked when I changed the porosity and permeability, (i.e.…
-
Failure to set up a constant boundary concentration by input a large volume in the first cell
Dear Sir or Madam, Sorry to disturb you. I set up a simple 1-D contaminant transport model using TOUGHREACT v3.0 following the 8.1 Problem 1 – Aqueous Transport with Adsorption (Linear Kd) and Decay…
-
Dirichlet and Robin Boundary problem
Dear Sir or Madam, Sorry to disturb you. I am setting up a very simple 1-D contaminant transport model. And I was wondering if I just apply the boundary water with a injection concentration C0 to…
-
Effect of the diffusion coefficient(D0) on the TOUGHREACT
Dear Sir or Madam, Sorry to disturb you. I found a problem when I run the example model in the 8.1 Problem 1 – Aqueous Transport with Adsorption (Linear Kd) and Decay (EOS9) in TOUGHREACT User Guide…
Latest Posts