-
TOUGHREACT1.2/ECO2N: About the inject rate and maximum pressure
Hi, everyone I'm using TOUGHREACT1.2/ECO2N with Petrasim. I am simulating the injection of CO2(isothermal) at a constant rate of 6.5kg/s（just one GENER）using a rectangle mesh,…
-
About the regular and radial mesh
Hi everyone, I was using TOUGHREACT V1.2 ECO2N to run a simple injection simulation，and When I set up multiple injection points(such as 5 points and each is spaced 20m apart, that is,…
-
About the toughreactEco2n v1.2 not have the “savechem”files
Hello everyone, I was using TOUGHREACT V1.2 to run a initial progress of HC field(no thermal field). There were some problems when adding the chemical field,…
-
About the direction of xyz during mesh creation
Hi， When using meshmaker to make xyz type meshes, I had some confusion regarding the designation of these directions: (1) Regarding the DEG setting, is the angle negative clockwise or…
-
V1.2 TOUGHREACT ECO2N IN PetraSim:Problems with initialization for flow and chemical field
Hi, I am new to TOUGHREACT and using v 1.2 ECO2N on PETRASIM to model CO2 Sequestration. And I have created a 2-D isothermal rectangle model and designed a temperature gradient of 3.…
-
TOUGHREACT/ECO2N:CANNOT FIND PARAMETERS AT ELEMENT * 1*
Hi Everyone, I'm new at using ECO2N of TOUGHREACT. And the following problem is encountered when I used PetraSim to simulate. It's a simple model. And I model a strata from -2260m to -2900m below…
-
The Example in TOUGH2's ECO2N：Radial Flow from a CO2 Injection Well
Dear all, I am using TOUGH2 ECO2N and I have confused about the example in Page 28 of the manual ECO2N: A TOUGH2 Fluid Property Module for Mixtures of Water,…
