-
EOS3-sink/source rates are piecewise constant, how to set up?
As described in the title, I want to set up sink/source rates which are piecewise constant,as shown in figure attached, I tried to set up the input file, but i'm confused about it?…
-
Help me? (EOS3) simulate a two-phase test.
Hi,everyone Right now, i want to simulate water drainage experiment, as first conducted by Liakopoulos(Liakopoulos, A.C., 1965. Transient Flow Through Unsaturated Porous Media.Ph.D. Dissertation.…
-
EXT2 cannot extract data from output file?
Hi everybody I use Ext2 to extract data from my output file, but it cannot work out, the generated file is empty, i don't know where is the problem? The error and output file are as follows,…
-
Can anybody explain the meaning of DELV in GENER?
I'm not very clear about DELV and EX, can anybody help me? thanks very much! sawyer
-
How to choose the module to simulate the Terzaghi's one-dimensional consolidation?
Hi everybody, as stated in the title,i want to simulate Terzaghi's one-dimensional consolidation, but i'm not sure which module of TOUGH2 i should choose, can any body tell me? thanks very much.…
-
The CO2 plume migraion is very strange.
The CO2 plume migraion is very strange. Can anybody tell me why is this case? Thanks very much. Sawyer.
-
How to determine the influence of boundary size?
Hi all, when i use tough2(ECO2N), i'm not sure whether the boundary size i chosen is appropriate, can anybody tell me how to determine the boundary size? thans very much! sawyer
-
How to determine the influence of boundary size
Hi all, when i use tough2(ECO2N), i'm not sure whether the boundary size i chosen is appropriate, can anybody tell me how to determine the boundary size? thans very much! sawyer
-
what is the meaning of the running time is negative?
Hello everyone, can anybody tell me why the running time is negative? As shown in the figure? Thanks very much! sawyer
-
(ECO2N)CANNOT FIND PARAMETERS AT ELEMENT * *, for help
Hi,dear all, I'm here agian. I was puzzled by a question for a long time, I appreciate anybody can provide some suggestion. I have attached my input file, MESH,INCON,and the output file,…
Latest Posts